dnipro-modular-ewa

Dnipro Modular Ewa

CV expander that unlocks Krait's full modular potential

4 HP Eurorack module

The Ewa Expander is a companion module for the Dnipro Modular Krait, adding CV modulation routing and clock/reset outputs to extend the Krait's functionality. It allows external CV signals to be routed to a wide range of Krait parameters including LFO, Random Generator, Knob Recorder, and Mixer destinations, giving performers hands-on modular control over the Krait's internal engines.

Features

  • Three CV inputs accepting -5v to +5v for modulating Krait parameters
  • CV routing menu to assign any CV input to any destination parameter with adjustable amount
  • Modulation destinations across four Krait sections: Knob Recorder, LFO, Random Generator, and Mixer
  • Clock output (CLO OUT) with encoder-tunable parameters
  • Reset output (RES OUT)
  • Connected to Krait via dedicated ribbon cable
  • EWA FOUND confirmation message on Krait display at boot
  • Supports waveform morphing, slew, amplitude, loop length, mix, phase, rate, and offset modulation targets
  • Requires latest Krait firmware for full functionality

Controls & Jacks (10)

  • Encoder— Encoder
  • CV IN 1— Accepts -5V to +5V. In mixer routing context, this is the INA signal (channel 1 mixed with channel 3). Route via CV routing menu to any Krai
  • CLOCK OUT— Outputs clock signal. Rate and parameters tunable via CLO button and Encoder.
  • CV IN 2— Accepts -5V to +5V. General-purpose CV input, fully assignable to any modulation destination.
  • RESET OUT— Outputs reset pulse. Use alongside CLOCK OUT to sync external modules.
  • Clock Menu— Clock Menu
  • CV 2 Select— Selects CV input 2 as the source being routed and edited in Krait's CV routing menu.
  • CV IN 3— Accepts -5V to +5V. In mixer routing context, this is the INB signal (channel 3 mixed with channel 1). Route via CV routing menu to any Krai
  • CV 3 Select— Selects CV input 3 as the source being routed and edited in Krait's CV routing menu.
  • CV 1 Select— Selects CV input 1 as the source being routed and edited in Krait's CV routing menu.

How-To Guides

  • Route a CV Input to an LFO Parameter
  • Record External CV into Knob Recorder
  • Offset a Recorded Knob Signal with CV
  • Morph LFO Waveform with External CV
  • CV-Controlled Slew on Random Generator
  • Voltage-Controlled LFO Phase Shifting
  • CV-Controlled Mixer Crossfade
  • Animated Loop Length on Random Generator
  • Set Up Krait Clock Output
  • Three-Source Layered Modulation

Explore the interactive Ewa panel on BleepDex — tap any control to learn what it does.

8c571ce